By Mark Higgins (aka DirtyLude)
Last Updated

Introduction -

You'll need to have an AEM or STR fuel rail for this to work. I wont go into the installation of the rail, since it's fairly simple. If you want to ditch the fuel line and banjo bolts that go between the rail and the fuel filter and replace them with -6 steel braided line. Here's pretty much all you need with part numbers.

1. Plug

Desc: 1/2"NPT NPT Plug-Internal Wrenching Qty.1 Per Pkg.

STR	Part #593204
AEM	Part #993205

2. AEM or STR Fuel Rail

3. 90 degree Elbow

If you want to be cool, you can get this swivel 90 degree connector. Unfortunately it only comes in 3/8"NPT, so it will only work with the STR rail.

Desc: -6 3/8 90Deg. Male AN to Male Swivel NPT

Otherwise you can get the normal 90degree non swivel connector.

Desc: -6 3/8 90 DEG. Elbow. Pipe Thread To A.N. Adapter

4. Hose Ends

You need 2 of these. One for each end of the fuel line.

Desc: -6 -6 Straight Auto-Fit Hose End. Use Perform-O-Flex, Auto-Flex or Ruff Stuff hose ONLY.

Part #300106

5. Fuel Line

You'll need very little of this. You could get away with just one foot. You'll most likely make some mistakes so get at least two feet. It can be pretty tough to force the hose onto the hose end, so be prepared to have a couple tries at it.

Desc: 1ft -6 Premium Racing Hose. THE BEST! (Use Swivel Seal or Auto-Fit Hose Ends)

Part #400060

6. Fuel Filter Adapter

This thing will screw right into the top of the fuel filter and has a -6AN fitting for the hose end.

Desc: 12mmx1.25 -6 Carburetor Adapter Solex, Dellorto, Mikuni

Part #991945

The carb adapter when screwed into the top of the fuel filter looks like this:

7. Stock Fuel Filter

No explanation needed.